Hummerkiller
Newbie
 
Reged: Apr 02 2006
Posts: 44
Loc: Texas USA
|
|






TLC Icon Specifications ENGINE The Icon's all-new Ram Jet 350 V8 uses state-of-the-art components developed by GM to give you all of the benefits of modern electronic engine management. Its cutting-edge electronic port fuel-injection system is designed for power, efficiency and ease of maintenance. Its Vortec heads with roller rockers provide smooth RPM response throughout its wide power band. Its air to fuel ratios are ideal under even the most extreme conditions providing superior cold starts and hot starts. Throttle response, power and drivability are always exceptional. And its oxygen sensor circuit and sealed fuel system provide responsible fuel efficiency and are easy on the environment. General Motors' crate-performance Ram Jet 5.7 350 V8 350 HP / 400 TRQ Displacement . . . . . . . . . . 349.7 ci Bore: . . . . . . . . . . 4.00-inch Stroke: . . . . . . . . . . 3.48-inch Compression ratio: . . . . . . . . . . 9.4:1 Block: . . . . . . . . . . Cast-iron, two-bolt main Cylinder heads: . . . . . . . . . . Cast-iron Vortec with 1.94/1.50-inch valves; 63cc chambers Crankshaft: . . . . . . . . . . Cast-iron one-piece rear-main seal Connecting rods: . . . . . . . . . . 5.7-inch forged powdered-metal with 3/8-inch bolts Pistons: . . . . . . . . . . Cast aluminum Camshaft: . . . . . . . . . . GM PN 14097395 hydraulic roller; 196/205 degrees duration at 0.050 inch tappet lift, 0.460/0.481-inch lift (with 1.6:1 rockers) Rocker arms: . . . . . . . . . . 1.6:1 roller Timing chain: . . . . . . . . . . Single roller
Nate and I were blown away but the fantastic work done on these vehicles and sent them a E-mail asking why they have not opted to build a M151 series vehicle???
Can you imagine a Mutt with these great new features???
It would put a Wrangler Rubicon to shame!
|
|
0 registered and 0 anonymous users are browsing this forum.
Moderator:
Print Topic
|
Forum Permissions
You cannot start new topics
You cannot reply to topics
HTML is disabled
UBBCode is enabled
|
Rating:
Topic views: 2002
|
|
|
|
|
|
Powered by UBB.threads™ 6.5.5
|
|